Menu Toolbar

This chapter describes the menus available in Quick Surface Reconstruction. Other menus are documented in the Infrastructure User's Guide.

		Insert
				Body...		Inserting a New Body
				Body in a Set...		Inserting a Body into an Ordered Geometrical Set
				Geometrical set...		Managing Geometrical Sets
				Ordered Geometrical Set...		Managing Ordered Geometrical Sets
				Cloud Edition		Cloud Edition
				Scan Creation		Scan Creation
				Curve Creation		Curve Creation
				Domain Creation		Domain Creation
				Surface Creation		Surface Creation
				Operations		Operations
				Transformations		Transformations
				Segmentation		Segmentation
				Analysis		Analysis
				Deviation Check		Deviation Check
				WireFrame		WireFrame
		Cloud Edition
				Activate		Activating a Portion of a Cloud
		Scan Creation
				Curve Projection		Projecting Curves
				Planar Sections		Creating Planar Sections
				XYZ Automatic Planar Sections		Creating Automatic Planar Sections
				Free Edges		Creating Free Edges
		Curve Creation
				3D Curve		Creating Associative 3D Curves and Creating Associative 3D Curves on Scans
				Curve on Mesh		Creating a Curve on Mesh
				Curve from Scan		Creating Curves from Scans
				Sketch from Scan		Creating a Sketch from Scan
				Intersection		Creating Intersections
				Projection		Creating Projections
		Domain Creation
				Clean Contour		Creating a Clean Contour
				Curves Network		Creating a Network of Curves
		Surface Creation
				Basic Surface Recognition		Recovering Basic Surfaces
				Power Fit		Creating Surfaces with PowerFit
				Multi-sections Surface		Creating Multi-sections Surfaces
				Surfaces Network		Creating a Network of Surfaces
				Automatic Surface		Creating a Surface Automatically from a Mesh
		Operations
				Join		Joining Surfaces or Curves
				Extrapolate		Extrapolating Surfaces
				Split		Splitting Geometry
				Trim		Trimming Geometry
				Curves Slice		Slicing curves
				Adjust Nodes		Adjust Nodes
				Split CleanContour		Splitting CleanContour
				Edge Fillet		Creating Edge Fillets
		Transformations
				Translate		Translating Geometry
				Rotate		Rotating Geometry
				Scale		Transforming Geometry by Scaling
				Symmetry		Performing a Symmetry on Geometry
				Affinity		Transforming Geometry by Affinity
				Axis To Axis		Transforming Elements from an Axis to Another
		Segmentation
				Segmentation by Curvature		Defining Areas by Curvature Segmentation
				Segmentation by Slope		Defining Areas by Slope Segmentation
		Analysis
				Information		Displaying Information
				Deviation Analysis		Performing a Deviation Analysis
				Curvature Mapping		Creating a Curvature Mapping
				Porcupine Analysis		Performing a Curvature Analysis
				Connect Checker Analysis		Checking Connections Between Surfaces
		Deviation Check
				Annotation Set		Creating Annotation Sets and Annotations
				Annotation		Creating Annotation Sets and Annotations
				Geometric Tolerances Checker		Checking Geometric Tolerances
				Deviation Report		Creating Deviation Reports
		WireFrame
				Point		Creating Points
				Line		Creating Lines
				Plane		Creating Planes
				Circle		Creating Circle