| This section describes the various icons available in the
Circuit Board Design workbench. The toolbar is located on the right in the default set-up. |
 |
Board See Creating a Board |
 |
Constraint Area See Creating a Constraint Area |
 |
Drill Holes See Drill Holes After Import |
 |
Panel See Creating a Panel |
 |
Export as IDF File See Exporting Data in an IDF File |
 |
Import in Context See Import in Context |
 |
Sketch See Sketching a Profile |
 |
Pad See Creating a Pad |
 |
Pocket See Creating a Pocket |
 |
Hole See Creating a Hole |
 |
See Patterns Sub-toolbar below |
 |
Component See Creating a Component |
 |
Export_Component See Export a Component |
|
|
Rectangular Pattern See Creating Rectangular Patterns in the Part Design User's Guide |
 |
Circular Pattern See Creating Circular Patterns in the Part Design User's Guide |
 |
User Pattern See Creating User Patterns in the Part Design User's Guide |