View Generation Modes

	This task explains the following modes of view generation in Structure applications: FTA View Advanced Front View Logical View Shell Expansion View
	The table below shows a comparison between these modes:
	Feature FTA View Front View/Advanced Front View Logical View Shell Expansion View Creates 3D annotations, 3D Dimensions Applicative views in Structure Logical drawings only in Structure Expanded view of shell in transverse direction Applicative Graphic Replacement Selectively based on objects geometry Globally Selectively based on objects relationships and interferences Selectively based on objects relationships and interferences Add Clipping later No Yes Yes No Good For Section Cut View standard arrangement views Decks and major bulkheads, where geometry is planar Shell plating views
	Note: If you are a DS Passport customer, you can read the QA00000006067 article from the Knowledge Base for more information about view generation of the moved or multiple instantiated CATPart or CATProduct containing one or more structural objects.