What's New?

Enhanced Functionality

Extracting Geometry

You can now choose whether to create one extract feature per propagated cell or only one feature for all cells.

Creating Edge Fillets

Use the tracks of the edge fillet ribbons as permanent features. These two tracks remain at the same position with respect to the support face. Select vertices as limiting elements. See Creating Edge Fillets.

Creating Tritangent Fillets

You can now select planes as limiting elements for tritangent fillets.

Creating Face-Face Fillets

You can now specify multiple limiting elements for face-face fillets.

Creating Circles

You can now select the new Center Computation check box to generate the center of a circle.
See Creating Circles.

Creating Fill Surfaces

You can now select the new Check if the fill creation required a trim check box to display a warning message if the created fill surface is trimmed and the boundaries do no longer correspond to isoparametric curves.

Creating Parallel Curve

You can now select the new Extrapolate up to support check box to extrapolate the parallel curve to the support boundaries.

Analyzing the Draft Angle

You can now access the list of analyzed elements using the new Elements box.

Enhanced Behavior of Draft Angle and Surfacic Curvature Analysis

The behavior of analyses on solids is enhanced and unified.

Creating Intersections

You can now extrapolate the intersection result onto the first element, second element, or on both elements.
See About Intersections.