PCBArea (Object)

Properties

Property AreaType() As (Read Only)

Allow to get the Type of a constraint area The possible values are : ROUTE_OUTLINE,

Returns:

The result of the method:
• S_OK if succeeded
• E_FAIL if failed

Property Heightmax() As

Allow to get and set the Height max of the constraint area This property is valid for the following constraints areas: OTHER_OUTLINE, PLACE_REGION

Returns:

The result of the method:
• S_OK if succeeded
• E_FAIL if failed

Property Heightmin() As

Allow to get and set the Height min of the constraint area This property is valid for the following constraints areas: PLACE_KEEPOUT

Returns:

The result of the method:
• S_OK if succeeded
• E_FAIL if failed

Property Identifier() As

Allow to get and set the Identifier of the constraint area This property is valid for the following constraints areas: OTHER_OUTLINE, PLACE_REGION

Returns:

The result of the method:
• S_OK if succeeded
• E_FAIL if failed

Property LAYER() As (Read Only)

Allow to get the position of a hole The possible values are : TOP,BOTTOM,BOTH,INNER,ALL It depends on the the type of the constraints area according to the IDF format This property is valid for the following constraints areas: OTHER_OUTLINE, ROUTING_OUTLINE, PLACE_OUTLINE, ROUTE_KEEPOUT, PLACE_KEEPOUT, PLACE_REGION,

Returns:

The result of the method:
• S_OK if succeeded
• E_FAIL if failed

Property OWNER() As

Allow to get and set the OWNER of the constraint area The possible value are MCAD,ECAD, UNOWNED

Returns:

The result of the method:
• S_OK if succeeded
• E_FAIL if failed